Blinds Chalet Good Housekeeping 2 Wood Blinds - Manual (Page 8)

8
PULL TO PROJECT
ALIGN & PRESS
GENTLY
CORRECT TWIST
TWIST UNTIL STRAIGHT
DETAILED STEPS – INSTALLING THE VALANCE:
1. TWIST: Twist all magnetic clips into the backside
valance route until straight. There are at least 2 clips
and each should be positioned 10” in from the ends of
the valance. (5 ½” in valances under 36”) Additional
clips should be spaced evenly between the 2 end clips.
Refer to the clip count chart below for magnetic clips
and valance safety straps.
ƒ Lay the valance face down with
the back side up. Turn each
clip to the side, insert the
clip’s dovetail (knob) into
the route and twist the clip
until it’s straight.
CLIP COUNT CHART:
ƒ Valance up to 36” wide = 2 magnetic clips and 1 safety strap
ƒ Valance 36” up to 52” wide = 2 magnetic clips and 2 safety straps
ƒ Valance 52” up to 82” wide = 3 magnetic clips and 2 safety straps
ƒ Valance 82” wide & up = 4 magnetic clips and 2 safety straps
2. PROJECT: Project the magnetic valance clips by
pulling them outward after attaching the them to the
backside valance route.
ƒ Lightly grasp & squeeze each clip on the top and
bottom with your forefinger and thumb and pull it
outward. (3 notches out = widest projection).
3. ALIGN: Align the valance to the headrail.
ƒ Hold the valance securely from the front side with
both hands, approach the headrail and position
the magnetic clip’s stop lip tabs to the top-front
lip of the headrail until it is level and in position.
3. PRESS: Press the valance GENTLY forward just
enough so the magnetic clips adhere to the headrail.
ƒ Do not press forward too hard or the magnetic
clips will adjust to their narrow projection. This
final clip projection adjustment step should be
performed after the safety straps are attached.