BASO Y71 - Manual

Installation Instructions
Issue Date May 6, 2008
© 2008 BASO Gas Products 1
Part No. BASO-INS-Y71, Rev. - www.baso.com
Y71 Regulator Conversion Kits
C
Regulator
Spring
B
Adjustment Screw
(Reuse this screw)
Regulator
Stack
Bottom Adjust Regulator
Regulator
Stack
Top Adjust Regulator
C
Regulator
Spring
B
Adjustment Screw
(Reuse this screw)
A
Seal Screw
A
Seal Screw
CAUTION!
Unit was converted to
3 to 6 in. W.C.
(7.5 to 15 mbar)
regulation.
Sample Caution Label
Figure 1: Regulator and Conversion Kit Parts
Applications
The Y71 Conversion kits allow the field conversion of
the pressure regulator of a BASO Gas Products®
G93, G96, G195, G196, or VLV gas valve.
The ranges of regulations are as follows:
• Bottom adjust regulators:
3 to 6 in. W.C. (7.5 to 15 mbar)
8 to 12 in. W.C. (20 to 30 mbar)
• Top adjust regulators:
3 to 6 in. W.C. (7.5 to 15 mbar)
6 to 12 in. W.C. (15 to 30 mbar)
The conversion kit contains the following:
• 1
regulator spring
• 1
seal screw
• 1 Caution label
Installation
IMPORTANT: Only qualified personnel should
install or service BASO® Gas Products. These
instructions are a guide for such personnel. Carefully
follow all instructions in this document and all
instructions for the appliance.
IMPORTANT: Make all gas installations in
accordance with applicable local, national, and
regional regulations.
!
CAUTION: Risk of Electric Shock.
Disconnect power supply before making electrical
connections to avoid electric shock.
!
WARNING: Risk of Explosion or Fire.
Shut off the gas supply at the main manual shutoff
valve before installing or servicing the valve. Failure
to shut off the gas supply can result in the release of
gas during installation or servicing, which can lead to
an explosion or fire, and may result in severe
personal injury or death.