beautypg.com

BASO L61LL User Manual

L61ll baso® safety shutoff device

background image

Installation Instructions

Issue Date

January 21, 2015

© 2015 BASO Gas Products

1

Part No. BASO-INS-L61, Rev. B

www.baso.com

L61LL BASO® Safety Shutoff Device

Installation

!

WARNING: Risk of Explosion or Fire.

Do not use the L61LL in Liquefied Petroleum
(LP) gas applications
. The L61LL is for use with
natural gas only. Pilot gas is not 100% shut off and
will continue to flow with the loss of pilot flame. Use
of LP gas may cause gas accumulation and may
result in severe personal injury or death.

IMPORTANT:

Only qualified personnel should

install or service BASO® Gas Products. These
instructions are a guide for such personnel. Carefully
follow all instructions in this document and all
instructions for the appliance.

!

WARNING: Risk of Explosion or Fire.

Shut off the gas supply at the main manual shutoff
valve before installing or servicing the L61LL. Failure
to shut off the gas supply can result in the release of
gas during installation or servicing, which can lead to
an explosion or fire, and may result in severe
personal injury or death.

!

CAUTION: Risk of Electric Shock.

Disconnect power supply before making electrical
connections to avoid electric shock.

IMPORTANT:

Make all gas installations in

accordance with applicable local, national, and
regional regulations.

To install the L61LL.

1.

Turn off all power to the appliance.

2.

Turn off the gas at the main manual shutoff valve
adjacent to the appliance.

IMPORTANT:

Do not loosen or tighten the

brass hex nut that fastens the brass therminal
bushing to the switch housing. The machined flats
on the terminal bushing must be parallel to the flats
on the switch housing. If not, the switch power unit
may distort and cause the safety switch to fail.

3.

Remove the metal snap-on cover from the L61LL
(not the brass hex nut).

4.

Mount the L61LL on a vertical surface with the
thermocouple connection positioned downward.

5.

Push the circuit wires through the conduit opening
on the bottom of the L61LL, strip the ends of the
wires just enough to put the bare wire under the
terminal screws, and connect the circuit wires
according to the appliance manufacturer’s
instructions or the wiring information on the label
(see Figure 1).

!

WARNING: Risk of Explosion or Fire

Do not attach both wires to one terminal on the
L61LL. Doing so bypasses and eliminates all safety
features provided by the L61LL and can lead to an
explosion or fire, and may result in severe personal
injury or death.

!

WARNING: Risk of Explosion or Fire

Verify that this device is wired in series electrically
with thermostats and other appliance operating
controls. Wiring the device in parallel with such
controls will defeat the safety features of this device
and may result in severe personal injury or death.