ALTANA Byko-Cut Universal Manual - Manual (Page 11)

10
English
Start-up and power-supply
5.2.3 Indentation tool for Bucholz hardness
To exchange the tool, loosen the screw until the
cutter can be pulled out. Insert a new tool and push
it against the rear of the mount, fasten the screw
(see Accessories and spare parts).
5.2.4 Attachment of Additional Weight for Buchholz indentation test
For Bucholz Indentation test the tool must press
with a force of 500 g perpendicular onto the surface.
Therfore an additional weight is attached to the
byko-cut.
5.3.1 Adjusting the revolver head
To adjust the revolver head
1. pull the holder
2. Turn it to left or right.
Once in the proper positions the holder locks in
place.
5.3 How to set up the cutting tools in the revolver head
Use the allen key 1.3 mm for adhesion tools Nr.
4-5 and for Buchholz indentation Nr. 6 for the other
cutting tools Nr 1-3 use allen key 2 mm.
Very important: loosen the screw and add the
cutting tool inside the support and check that the
highest tip of the tool is close to the wheel side.