ALTANA Byko-Cut Universal Manual - Manual (Page 10)

9
English
Start-up and power-supply
5.2 Installation of cutting tools
The byko-cut universal comes complete with three
cutting tools for film-thickness (tools 1-3). The
optional tools for cross-cut can be mounted to the
related supports (No. 4-6) of the revolver head as
well as the indentation tool for Buchholz hardness to
be used in conjunction with the additional weight.
5.2.1 Cutting tools No. 1-3
Are fixed with hexagon socket screws beside the
particular support of the revolver head. To insert or
replace the cutting tool, loosen the screw until the
tool can easily be moved in the support. Insert the
tool and push it against the rear of the support and
tighten the screw (see Accessories and spare
parts).
5.2.2 Multi-cut tool for cross-cut
Cross-cut 1mm, 1.5 mm and 2mm tools can be
used. The screw holding the cutter is beside the
holder. To exchange the tool, loosen the screw until
the cutter can be pulled out. Insert a new tool and
push it against the rear of the mount, fasten the
screw (see Accessories and spare parts).