ALTANA Byko-Drive Short Instructions - Manual (Page 2)

Measure what you see.
Additives & Instruments
A member of
BYK-Gardner USA · 9104 Guilford Road · Columbia · MD 21046 · USA · Phone +1-301-483-6500 · Fax +1-301-483-6555 · www.byk.com/instruments
285 021 536 E 1002
ENGLISH
byko-drive
Instrument Description
Speed setting:
2 speeds are available: 10 mm/sec or 1 in/sec.
• To change the speed, press and hold the “Forward Button“ as well as
the “Set End Position“ for 5 seconds and release it.
The LED will blink twice and the carriage will move to the start position.
Definition of drawdown length:
Set start position:
• Start by pressing the “Forward Button”
• Press the “Forward Button” again to stop the carriage at
the desired position.
• Save the new start position by pressing the “Set Start Position”
The LED will blink once as a confirmation.
Set end position:
• Press the “Forward Button” and press it again to stop the
carriage at the desired position
• Save the new end position by pressing the “Set End Position”
The LED will blink once as a confirmation.
Reset ”Start/End” position:
• Press and hold the “Set Start Position”
and “Set End Position” for 5 seconds.
1
4
3
2
1. Power switch
2. Keyboard
3. Vacuum plate
4. Pushbar with weight bar fixtur
Forward Button
Reverse Button
Set End Position
Set Start Position