ALTANA Byko-Drive Manual - Manual (Page 15)

13
English
Operation
Once the substrate is held in place, position an
appropriate Bird applicator, wire rod, square appli-
cator or other applicator bar in front of the Pushbar.
To keep wire rods from rotating and when additio-
nal weight is needed for other applicators, set the
Weight over the pins of the Pushbar allowing the
rubber strips to hold the applicator in place. The
narrow space is for 10 mm diameter rods, the wider
space is for 1/2” (12.6 mm) diameter rods.
Apply an appropriate amount of coating immediate-
ly in front of the applicator. Press the forward button
and the application will begin.
At the end of the travel, the Applicator will stop au-
tomatically. Remove the applicator for cleaning and
press the Reverse button. Once the carriage has
returned to the start position, remove the coated
substrate.