AERCO Modbus Communications Manual for ECS - Manual (Page 8)

4
To change the modbus address:
The address is defaulted to 1 from
the factory. Refer to the Button map
below for all panel navigation
instructions.
Scroll
4. Go to the home screen by pressing the Page
and Scroll buttons at the same time.
5. CHANGING COMMUNICATION ADDRESSES ON THE AERCO
EUROTHERM TEMPERATURE CONTROLLER
1. Page to the ACCS list and
Scroll
down the list to codE.
2. Enter 24 using the Up Arrow.
The number will display and flash
PASS.
3. Scroll to Goto (current value is OPEr) and use the
Down Arrow
to enter a value of Full. The entry is
confirmed by the flashing of the lower display
momentarily off and then on.
Button Map
Down
Arrow Page Up
Arrow