Acura 2000 RL - Owner's Manual - Manual (Page 94)

HomeLink Universal Transmitter
Training With a Rolling Code
System
For security purposes, newer garage
door opening systems use a "rolling"
or variable code. If you know that
your garage door opener has a
rolling code, or you have been
unable to train the transmitter after
several attempts, use the following
procedure. You will need someone to
help you.
1. Make sure you have properly
completed the "Training the
Transmitter" procedure.
2. Find the "Training" button on your
garage door opener motor/control
unit. The location will vary,
depending on the manufacturer.
The manufacturer's
documentation may help.
3. Press the Training button on the
motor/control unit until the
Training light comes on, then
release it.
4. Press and release the desired
button on the HomeLink
transmitter.
5. Press and release the HomeLink
transmitter button again. This
should turn off the training light
on the motor/control unit. (Some
systems may require you to press
and release the button three times.)
6. Press the transmitter button again.
It should operate the garage door.
Instruments and Controls
TRAINING BUTTON
GARAGE DOOR
OPENER MOTOR/
CONTROL UNIT
Main Menu
Main Menu Table of Contents