beautypg.com

Lights – Acura 2000 RL - Owner's Manual User Manual

Page 255

background image

Lights

1. Use a wrench to loosen the light

assembly's mounting bolt.

2. Remove the light assembly from

the bumper.

3. Remove the electrical connector

from the bulb by pulling the
connector straight back.

4. Remove the rubber weather seal

by pulling on the tab.

5. Unclip the end of the hold-down

wire from its slot. Pivot the wire

out of the way and remove the

bulb.

6. Insert the new bulb into the hole,

making sure the bulb is right side
up and the nubs on the bulb base
fit in the indentations in the fog
light assembly. Pivot the hold-
down wire back in place and clip
the end into the slot.

7. Install the rubber seal over the

back of the fog light assembly.

Make sure it is right side up; it is
marked

8. Push the electrical connector onto

the new bulb. Turn on the front
fog lights to test the new bulb.

9. Put the light assembly into the

bumper. Tighten the mounting
bolt.

Maintenance

WEATHER SEAL

BULB

HOLD-DOWN

WIRE

CONNECTOR

BOLT

Main Menu

Main Menu

Table of Contents