Acura 2000 RL - Owner's Manual - Manual (Page 92)

HomeLink Universal Transmitter
Training the Transmitter
Before you can use the HomeLink
Universal Transmitter to operate
devices around your home, it must
"learn" the proper codes. For
example, to train the transmitter to
open and close the garage door:
1. This step erases all previously learned
codes. Perform this step before
training the transmitter for the very
first time. Press and hold the two
outside buttons until the red light
in the transmitter flashes
(approximately 20 seconds).
Release the buttons.
2. Hold the end of the garage door
opener remote control 1 to 3
inches from the HomeLink
transmitter. Make sure you are
not blocking your view of the red
light in the transmitter.
3. Select the transmitter button you
want to train.
4. Press the button on the remote
control and the button on the
transmitter at the same time. Hold
down both buttons.
5. The red light in the transmitter
should begin flashing. It will flash
slowly at first, then rapidly.
6. When the red light flashes rapidly,
release both buttons. The
transmitter should have learned
the code from the remote control.
7. Test the transmitter button by
pushing it. It should operate the
garage door.
8. Repeat these steps to train the
other two transmitter buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
CONTINUED
Instruments and Controls
Main Menu
Main Menu Table of Contents