Acura 2000 RL - Owner's Manual - Manual (Page 93)

HomeLink Universal Transmitter
Canadian Owners:
The remote control you are training
from may stop transmitting after two
seconds. This is not long enough for
the HomeLink transmitter to learn
the code. Release and press the
button on the remote control every
two seconds until the transmitter has
learned the code.
If you are programming the
transmitter to operate a garage door
or gate, it is recommended that you
unplug the motor for that device
during programming. Repeatedly
pressing the remote control button
could burn out the motor.
The HomeLink transmitter stores
the code in a permanent memory.
There should be no need to retrain
the transmitter if your car's battery
goes dead or is disconnected.
Retraining a Button
To train an already programmed
transmitter button to operate a new
device:
1. Select the transmitter button you
want to train.
2. Press and hold the transmitter
button until the red light begins to
flash slowly (approximately 20
seconds).
3. While continuing to hold the
transmitter button, place the
remote control for the device 1 to
3 inches from the HomeLink
transmitter.
4. Press and hold the button on the
remote control. Hold both buttons
until the red light begins to flash
rapidly.
5. Release both buttons. The
transmitter should now be trained
to operate the device.
Instruments and Controls
Main Menu
Main Menu Table of Contents