Preparing to drive, starting the engine – Acura 2008 MDX - Owner's Manual User Manual
Page 343
CONTINUED
Check the adjustment of the
inside and outside mirrors (see
page
).
Check the steering wheel
adjustment (see page
).
Make sure the doors and tailgate
are securely closed and locked.
Fasten your seat belt. Check that
your passengers have fastened
their seat belts (see page
).
When you start the engine, check
the gauges and indicators in the
instrument panel, and the
messages on the multi-information
display (see pages
,
and
).
Without touching the accelerator
pedal, turn the ignition switch to
the START (III) position, then
release the ignition switch. You do
not need to hold the ignition
switch in the START (III) position
to start the engine. Depending on
the outside temperature, the
starter motor runs for about 6 to 9
seconds until the engine starts.
If you hold the ignition switch in
the START (III) position for more
than 7 seconds, the starter motor,
depending on the outside
temperature, runs for about 10 to
25 seconds until the engine starts.
If the engine does not start, wait at
least 10 seconds before trying
again.
Make sure the shift lever is in
Park. Press on the brake pedal.
In cold weather, turn off all
electrical accessories to reduce
the drain on the battery.
Apply the parking brake.
Your vehicle’s starting system has an
auto control mode. When you turn
the ignition switch to the START
(III) position, this feature keeps the
engine’s starter motor running until
the engine starts. Follow these
instructions to start the engine:
1.
2.
3.
4.
6.
7.
8.
9.
15
124
81
10.
63 72
154
Preparing to Drive, Starting the Engine
Starting the Engine
D
riv
ing
339
The immobilizer system protects your
vehicle f rom thef t. If an improperly-
coded key (or other device) is used, the
engine’s f uel system is disabled. For
more inf ormation, see page
.
128
2008 MDX
Table Of Contents
Main Menu