Acura 2008 MDX - Owner's Manual - Manual (Page 182)

Push AUTO or . The selected
temperatures appear in the display.
When the indicator in the DUAL
button is off, you can adjust both
sides to the same temperature by
adjusting the driver’s temperature
control buttons.
To set the driver’s side temperature
to a different value than the
passenger’s side, press the DUAL
button, then press either of the
driver’s temperature control button
( or ). To set the passenger’s side
to a different value than the driver’s
side, press either of the front
passenger’s temperature control
button ( or ). You can adjust the
passenger’s side without pressing
the DUAL button first.
When the indicator in the REAR
button is off, the temperature of the
rear passenger compartment is
synchronized to the driver’s side set
temperature. You will see the AUTO
SYNC on the system display of the
rear control panel.
To set the temperature of the rear
passenger compartment to a
different value than the driver’s side,
press the REAR button, then press
either temperature control buttons
on the back of the center console.
The word ‘‘SYNC’’ in the display
goes out. You can also adjust the
rear temperature without pressing
the REAR button first. Pressing
either button causes the indicator of
the REAR button to turn on.
When you set each temperature to
its lower limit or its upper limit, it will
be displayed as ‘‘ ’’ or ‘‘ ’’.
Climate Control System
178
2008 MDX
Table Of Contents Main Menu