On device controls and display, Startup display, Standard display – Kofax Communication Server 9.1.1 User Manual
Page 92
Environment Guide
Version 3.00.04
92
© Copyright Kofax, Inc. All information is subject to change without notice.
Connection
Left LED
Right LED
Example
no LAN signal detected
off
off
10 Mbps LAN connection
blinking green
1 sec on/off
flickering yellow to indicate activity
on LAN
100 Mbps LAN connection
steadily green
flickering yellow to indicate activity
on LAN
Description of TC23/TC24/TC26 LEDs
LED status
Left Right
TC23.3
TC24
TC26
off yellow
interface reset, not yet booted, or not configured at
all
steadily red off
interface initialized, but the line not active
(line disconnected or out of order)
steadily red steadily green
interface initialized, the line is connected
but not functioning properly
TC24: not synchronous
TC23/TC26: not used
off steadily green
interface initialized, line connected and active
flicker green steadily green
active transmission via this line
TC26 interface only
On device controls and display
Model 305 features a 16x2 character display and two pushbuttons on the front panel. On the LCD, various
status information are displayed. The buttons are used to navigate through menus, to set the IP address,
net mask and gateway of LAN1, and to reboot the device.
Startup display
On startup Model 305 displays following information:
TC16 BIOS Version + IP-Address
TC/LINUX Version
Afterwards you will see on the display that the Model 305
is waiting for the KCS server. As soon as TCOSS
connects to the Model 305, you will get two more display screens for updating the software and for
initializing the DSPs.
Standard display
By default Model 305
displays either ``Not connected'' followed by the IP address, or the current line
statistics. Line statistics is displayed in the form ``
for example ``12/32 lines'' means that out of a total of 32 configured lines, 12 are active.
If there is no button pressed for a certain time, Model 305
will return to standard display automatically.