Kofax Capture - Manual (Page 21)

Installation
Kofax Reporting Administrator's Guide 21
Configuration hints:
▪ In the WSA Sender, configure the NLB IP address and port in the Central URL field. Refer
to Configuring WSA .
▪ If you are using remote configuration of WSA Receiver from the Kofax Reporting
Configuration tool, do not use the NLB port! You must configure each WSA Receiver node
individually. Refer to Configuring WSA Remotely .
Installing Windows NLB
1 Install Windows NLB on each WSA Receiver node.
On Windows Server 2008, NLB has to be installed as an additional feature of the
operating system.
a Start Server Manager.
b Select Features.
c Click Add Features
d Select Network Load Balancing.
e Click Next, then click Install.
On Windows Server 2003, NLB has to be installed as an additional service in the Local
Area Network Properties.
a Start Windows Control Panel.
b Go to Network Connections.
c Right-click Local Area Network and select Properties.
d Click Install.
e Select Service and click Add.
f Select Network Load Balancing and click OK.
g Activate Network Load Balancing and click Close.
2 Configure a fixed IP address on each node.
3 The recommended method to create an NLB cluster is using the Windows Network Load
Balancing Manager. Run "nlbmgr".
4 Create a new cluster:
a Right-click Network Load Balancing Cluster and select New Cluster.