Hardy Advantage Weigh Modules LPB - Manual (Page 26)

HI LPB SERIES LOAD POINT ASSEMBLY
Page 20
Step 1. Use a box end wrench to loosen the adjust-
ment hex nut that fastens the Anti-Lift Off
Device to the top plate. (See Fig. 22)
Step 2. Adjust the hex screw with your fingers or
box-end wrench until the gap between the
base plate and washer are between .0785”
(2mm) and .1570” (4mm). (See Fig. 22)
Step 3. Use a box-end wrench and tighten the
adjustment hex nut.
Replacing the Load
Sensor Step 1. Use a box-end wrench to loosen the nut
that fastens the anti-lift off device to the
top plate. Remove the anti-lift off device.
(See Fig. 23)
Step 2. Use a box-end wrench to remove the two
hex bolts that fasten the ground strap to the
top plate and the base plate. Remove the
ground strap.
Step 3. Jack up the vessel support leg and lift off
the top plate.
Step 4. Remove the two load sensor bolts that fas-
ten the Load Sensor to the base plate with
a box-end or crescent wrench. (Fig. 23)
FIG. 23: EXPLODED ISO VIEW OF FREE
SLIDING LOAD POINT ASSEMBLY
Step 5. Remove the old load sensor.