Hardy Advantage Weigh Modules LPB - Manual (Page 24)

HI LPB SERIES LOAD POINT ASSEMBLY
Page 18
top plate to the support bracket. If you
want to use fasteners to fasten the top plate
to the support bracket, use a marker or
scribe and trace the thru hole pattern of the
top plate on the support bracket. Drill four
thru holes or drill and tap four holes for the
fasteners. Install the top plate to the sup-
port bracket using the four fasteners.
Step 3. With the top plates installed, put the vessel
support bracket with the top plate onto the
pins of the load cells. Make sure that the
sliding load cell pins are riding on the
stainless plate. Make sure that the fixed
pin is centered in the top plate housing.
The horizontal position is not critical but
the vertical position is. Use the C dimen-
sions to determine the proper height
between the support surface and the top of
the top plate. (See Fig. 20)
Step 4. Level the installed load point assemblies
and make adjustments according to the
following top plate level requirements.
FIG. 20: HEIGHT DIMENSION C
MODEL # HEIGHT C
HI LPB44-43
3.149”
(80)
HI LPB110-43
HI LPB225-43
HI LPB450-43
TABLE 2: