CyberData VoIP Intercom - Manual (Page 21)

Installing the VoIP Intercom
Intercom Setup
Operations Guide 930181B CyberData Corporation
13
2.2.6 RTFM Switch Jumper
When the Intercom is operational and linked to the network, use the Reset Test Function
Management (RTFM) switch (see
Figure 2-11 ) on the Intercom board to announce and confirm the
Intercom’s IP Address, test that the audio is working, and check the volume.
Note You must do this test prior to final assembly. Please remember to remove the RTFM switch
jumper prior to final assembly.
Figure 2-11. RTFM Switch Jumper
2.2.6.1 Announcing the IP Address
To announce an Intercom’s current IP address:
1. Unplug the intercom.
2. Install the RTFM jumper.
3. Plug the network cable into the intercom to supply power to the intercom. The LED will
illuminate during initialization, blink once, and then turn off.
4. The intercom will announce the IP address.
Note If you installed the RTFM jumper, and if you press the Call button for 10 seconds, the
default factory settings will be restored.