4 call button and indicator light, 1 initial power, 2 calling – CyberData VoIP Intercom User Manual
Page 18
CyberData Corporation
930181B
Operations Guide
Installing the VoIP Intercom
Intercom Setup
10
2.2.4 Call Button and Indicator Light
2.2.4.1 Initial Power
Upon initial power or reset, you will see the following:
•
The light is on.
•
The light will blink twice to indicate that the intercom has acquired its network settings and
is operational.
•
The first blink indicates that the intercom has acquired its network settings.
•
The second blink indicates that the intercom is operational.
2.2.4.2 Calling
●
You may initiate a call by pressing the Call button.
●
An active call is indicated by the light blinking at one second intervals.
●
The intercom will automatically answer an incoming call.
●
You can press the Call button to terminate an active call whether the call was an incoming call
or a call that was initiated by you.
Figure 2-8. Call Button and Indicator Light
Call button and indicator light