FRITSCH PULVERISETTE 13 classic line - Manual (Page 7)

2 Safety information and use
2.1 Requirements for the user
This operating manual is intended for persons assigned with operating
and monitoring the Fritsch PULVERISETTE 13 classic line. The operating
manual and especially its safety instructions are to be observed by all
persons working on or with this device. In addition, the applicable rules
and regulations for accident prevention at the installation site are to be
observed. Always keep the operating manual at the installation site of
the PULVERISETTE 13 classic line.
People with health problems or under the influence of medication,
drugs, alcohol or exhaustion must not operate this device.
The PULVERISETTE 13 classic line may only be operated by authorised
persons and serviced or repaired by trained specialists. All commis-
sioning, maintenance and repair work may only be carried out by techni-
cally qualified personnel. Qualified personnel are persons who, because
of their education, experience and training as well as their knowledge of
relevant standards, regulations, accident prevention guidelines and oper-
ating conditions, are authorised by those responsible for the safety of
the machine to carry out the required work and are able to recognize
and avoid possible hazards as defined for skilled workers in IEC 364.
In order to prevent hazards to users, follow the instructions in this
manual.
Malfunctions that impair the safety of persons, the PULVERISETTE 13
classic line or other material property must be rectified immediately. The
following information serves both the personal safety of operating per-
sonnel as well as the safety of the products described and any devices
connected to them: All maintenance and repair work may only be per-
formed by technically qualified personnel.
This operating manual is not a complete technical description. Only the
details required for operation and maintaining usability are described.
Fritsch has prepared and reviewed this operating manual with the
greatest care. However, no guarantee is made for its completeness or
accuracy.
Subject to technical modifications.
2.2 Scope of application
PULVERISETTE 13 classic line is a disk mill for fine grinding by batches or
continuous fine grinding of hard-brittle to medium-hard solids from the
fields of mining and metallurgy, geology and mineralogy, and the glass
and ceramics industry.
The feed size maximum is 20 mm per edge; the final fineness that can be
achieved ranges from approx. 12 mm (greatest gap width) to 0.1 mm
(smallest gap width) depending on the set gap width.
Safety information and use
- 7 -