FRITSCH PULVERISETTE 13 classic line - Manual (Page 22)

6.1 Setting the minimum gap width
The minimum gap width is limited to 0.1 mm in the condi‐
tion of delivery.
A stop screw with lock nut is located at the back left of the
sliding table, which limits the forward movement of the
sliding table. This prevents the grinding disks from touching
inadvertently.
The minimum gap width has to be reset after every change
or prolonged use of the grinding disks. Grinding disks may
have different thicknesses depending on the wear.
The procedure for setting the minimum gap width is as follows:
1.
The stop screw has to be readjusted. To do this, remove the black
cover cap.
2. Remove the lock nut with a 13 mm spanner.
3. Turn the stop screw back by using a 4 mm hexagon socket screw
key to turn it to the left (max. 2 turns).
Using the device
- 22 -