FRITSCH PULVERISETTE 13 classic line - Manual (Page 28)

7.2 Comminution of coarse material in combination with the Jaw Crusher PULVERI-
SETTE 1 classic line
The disk mill PULVERISETTE 13 classic line is used in combination with
the Jaw Crusher PULVERISETTE 1 classic line for comminution of coarse
material before its subsequent use.
The comminution is done in this combination in a single pass with 95 mm
(or 65 mm) feed size up to an average particle feed size (d
50
) of 0.1 mm.
The jaw crusher is placed on a mounting rack (order no. 43.5100.00) over
the disk mill. The material roughly crushed in the jaw crusher passes via
a hopper directly into the funnel of the disk mill.
CAUTION!
Feed in only as much sample material into the PULVERI-
SETTE 1 classic line as the PULVERISETTE 13 classic line itself
can grind. (This depends on gap width; comminution by
batches with collection container: max. 2 L sample mate-
rial)
Accessories
- 28 -