Cub Cadet U-Channel Beam Style - Manual (Page 9)

Engine and pump
5
MTD log splitters are available with a variety of horizontal and vertical shaft engines. This manual covers proce-
dures that are the same for all engine models available. Specific engine procedures are covered in the engine’s ser-
vice manual.
Horizontal shaft engines
To remove/replace the engine:
1. Remove the three coupling support bracket nuts
using a pair of 1/2” wrenches. See Figure 2.1.
NOTE: A thin headed wrench (like a tappet wrench) is
needed to fit between the engine and the coupling
support bracket.
2. Slide the pump and the coupling support bracket off
as one assembly.
NOTE: support the pump. DO NOT let the pump hang by
the hoses.
3. Remove the spider from the engine coupling.
4. Remove the spacer shield.
5. Remove the four engine mounting screws using a 9/
16” wrench.
6. Remove the engine from the log splitter.
Figure 2.1
Nuts
coupling support bracket
Spacer shield
Thin headed
wrench
Figure 2.2
Engine mounting
screws
CHAPTER 2: ENGINE AND PUMP