COP-USA CD55-SDI-IRWPTK - Manual (Page 23)

22
6
Start Pattern Tour of
Group No.
Call 80+ Call pp+ Call 97 pp means：Group No.1‐4
7
Stop Auto Mode/End up
Setting
Call 96
8 Open OSD Menu Set 95（or Call 95）
9 Remote Reset Call 94
10 Recover Factory Default Call 82
2) System Self‐Testing
The dome will do self‐testing after power up, and system status will show
“Normal” if system Is running normally. If error happens, testing result will be
shown in “
○ ” or “ X ”. “ ○ ” means normal and “ X ” means error. Please check the
according meaning as follows:
3) OSD Menu Operations
Call Preset 95 to enter the main OSD menu (or call preset No.1 two
times continuously within two seconds)
Control the joystick to move the cursor around the menu
Press “Iris Open” to enter the menu for selections
Move the joystick up and down to select the item
Press “Iris Open” to confirm the selection
Press “Iris Close” to cancel the selection
*Note: If your controller does not have a joystick, use the up or down key.
Serial No. 1 2 3 4 5 6
Meaning Dip Switch Temperature Sensor Storage Pan Tilt Camera