Compex Runner - Manual (Page 18)

16
English
2. Connections
Connecting the cables
The stimulator cables plug into the 4
sockets on the front of the device.
Four cables can be connected
simultaneously to the four channels of the
device. Both the sockets and the cables are
colour-coded to simplify use and facilitate
identification of the different channels:
blue = channel 1 green = channel 2
yellow = channel 3 red = channel 4
The Runner stimulator bears the label
m i
-ready, in other words it can use
certain functions of the
m i
technology
if a stimulation cable fitted with the
m i
-
SENSoR system is connected. This cable,
sold separately, gives access to the
m i
-
SCAN ,
m i
- TENS and
m i
- RANGE functions.
It is connected to any one of the four
stimulation channel sockets located on
the front of the device and two electrodes
are “clipped” on to it in the same way as
for a conventional cable.
Connecting the charger
The Compex has considerable operating
autonomy, as it uses rechargeable
batteries.
To recharge them, use the charger supplied
with your device and connect it to the
front of the device, then plug the charger
in a socket.
Remove any stimulation cables connected
to the stimulator before recharging it.
We strongly recommend you fully charge
the battery before using it for the first time
as this will improve its autonomy and life
span.
3. Preliminary settings
Before using the unit for the first time,
you should select the working language
of the device which is displayed on the
options screen. Follow the instructions
below. Afterwards, for the greatest comfort,
Compex offers you a number of setting
options (choice of language, screen contrast
adjustment, adjusting backlighting and
sound volume setting). To change any of
these settings, bring up the options screen
by holding the on/off button on the left of
the stimulator for a few seconds.
1b Use the channel 1 +/- button to choose
the language you wish to use.
1c Use the channel 2 +/- button to adjust
the contrast of the screen.
1d Use the channel 3 +/- button to adjust
the volume.
1e Use the channel 3 +/- button to adjust
the volume.
on : backlighting always on.
off : backlighting always off.
auto : backlighting activated whenever a
button is pressed.
1a Press the on/off button to validate the
selected parameters. Your stimulator saves
your options. It is now ready for use with
the settings you selected.