ChemoMetec NC-3000 - Manual (Page 42)

8 Troubleshooting - Error messages
991-3001 Rev. 1.3 June-2013 26
Figure 16. Location, removal and inspection of the fuse
Disconnect the power supply from the NucleoCounter
®
NC- 3000™. Then remove the
fuse holder using a screwdriver as indicated in Figure 16 (turn CCW). Inspect the
fuse. If it needs replacement use one as described by ChemoMetec A/S .
If the NucleoCounter
®
NC- 3000™ does not turn on after replacement of the fuse, or
if the fuse was not broken, please contact ChemoMetec A/S or the local
representative for further instructions.