ChemoMetec SCC-100 - Manual (Page 14)

1 Installation
4
Figure Figure Figure Figure 5 55 5 The installation has been successful.
If the installation was successful the dialogue in figure 5 will appear. Click “Finish” to
complete the installation.
Now the USB device driver for the NucleoCounter SCC-100 is successfully installed. It will
not be necessary to redo the installation unless you wish to use the NucleoCounter SCC-
100 on another computer or if you reinstall Windows 2000.
1.2 Installation of SomaticView TM – Windows 2000
The NucleoCounter SCC-100 CD-ROM contains the necessary software for the installation
of SomaticView. SomaticView allows viewing of images and results from the
NucleoCounter SCC-100 instrument.
SomaticView will be installed in a separate folder containing the necessary software (by
default C:\SomaticView). Any data collected from the NucleoCounter SCC-100 will also
be stored in separate data folders within that folder. It is necessary to place the
SomaticView software in a folder in the root directory of the local hard disk named
"SomaticView" as suggested by the installation software.
It is possible to choose a different location for the data but this will
disable the data collection capabilities of SomaticView and is
therefore not recommended.