Checkline TI-007DL - Manual (Page 9)

4. Press the SEND key to toggle the status of the beeper on/off.
5. Press the MODE key once again to return to measurement mode.
Alarm Mode
1. Press the ON/OFF key to power up the TI-007DL
2. Press the MODE key to activate features and settings
3. Mode will start with ALAr feature and current status
4. Press send key to toggle ALAr status on/off
5. Status ON – A nominal value will be displayed with the units IN/MM flashing.
6. Press the UP or DOWN arrow keys to scroll to the desired nominal thickness value.
7. Press SEND key to select the desired nominal value and return to mode menu.
8. Press MODE key once to return to measurement mode.
– 9 –
5. Press the SEND key once again to select the file.
Note: The display will flash the FILE/F-04 (The selected file) symbol.
6. Press the MEM key, once again, to advance to the storage locations in the file
selected.
Note: The display will flash the current storage location (L007, L039, etc ),
followed by the status of the location. The storage location can contain one of
three possible things:
a. A measurement that was previously stored.
b. A clear location, indicated by the CLr symbol.
c. Obstruct (ObSt), indicating that a measurement could not be obtained.
7. Press the UP/DOWN arrow keys to advance to the desired cell location.
8. Take a measurement and press the SEND key to store a reading in the
desired location.
The data logger will automatically advance to the next storage location in
sequential order.
9. Repeat step 8 as required.
Clearing a Storage Location
The user may require a storage location, that is currently full, be over written.
This procedure is outlined in the following steps:
Note: Assuming the steps in Using The Data Logger have been completed, and step 8
is being repeated.
1. Press the UP/DOWN arrow keys to move to the location to be over written.
Note: If the user attempts to write to a location that is currently full, the display
will flash the FuLL symbol.
2. Press the CLR key to delete the contents of the storage location. The display
will flash the storage location (L011, L099, etc.) and the CLr symbol.
3. Take another measurement, and press the SEND key to write to the same storage
location just cleared.
Clearing an Entire File
The user may require the contents of an entire file be completely cleared of all mea-
surements. This would allow the user to start a new list of measurements starting at
storage location L001. The procedure is outlined in the following steps:
1. Press the ON/OFF key to power up the TI-007DL.
2. Press the MEM key to activate the data logging functions and settings.
3. Press the SEND key to enter file setup.
4. Press the UP/DOWN arrow keys to scroll to the file that will be cleared of
all measurements.
5. Press the SEND key once again to select the file.
Note: The display will flash the FILE/F-05 ( The file selected by the user ) symbol.
– 12 –