Aviom AV-M8 - Manual (Page 35)

27 Av-M8 M
ic
i
nput
M
odule
u
ser
G
uide
A-Net Connections
In a simple Pro16 system, the easiest connection method uses what is called a
daisy chain. That is, each A‑Net device is connected in series. The first device
in the chain receives the A‑Net signal from the Pro16 input module such as
the AN‑16/i Input Module or a compatible Pro16 console card. Each successive
A‑Net compatible device gets its A‑Net connection from the A‑Net Out jack
of the device preceding it in the chain.
Series Connection of A-Net Devices
The diagram below illustrates a series connection of A‑Net devices.
A-Net
In Out
A-Net
In Out
A-Net
In Out
A-Net
In Out
In this diagram, A-Net is connected from device to device using Cat-5e cable.
The A-Net Out port on the first device connects to the A-Net In port on the
next, and so on.
There is one drawback to this connection method, however. If one A‑Net
device in the chain is disconnected from the A‑Net signal chain, all units
beyond this point will not get any audio until the unit is reconnected to a
valid A‑Net source.
A parallel A‑Net connection solves that problem. By using the optional A‑16D
or A‑16D Pro A‑Net Distributor, parallel A‑Net connections are possible. In
fact, any combination of series and parallel connections can be used to solve
even the most complex audio routing problems.
Parallel A-Net Routing
Connecting A‑Net devices in parallel involves the addition of an A‑Net
distributor. Any number of A‑Net distributors can be added, creating an
infinite number of digital splits.
Using an A-Net Distributor
A variety of A‑Net compatible components are shown connected in parallel
to an A‑Net Distributor in the diagram below.