Pan leds, Using solo mode, Muting a channel – Aviom A-16 User Manual
Page 30

Aviom A-16 Personal Monitor Mixing System
22
23
Pan and Volume Controls
To make changes to a Channel:
• Select a Channel by pressing its numbered button—the upper LED will
light.
• Rotate the
V
OLUME
knob to the right to increase the volume, to the left to
lower the volume
• While the Channel is still selected, you can also change the Pan setting.
Rotate the
P
AN
knob left or right to change the position of the Channel in
the stereo field.
Pan LEDs
The Pan indicator is made up of five LEDs. The center LED is green. The LEDs on
either side of center are red. As you turn the
P
AN
knob, the LEDs will light in various
combinations to provide the maximum number of position indicators with the fewest
number of lamps. At either end of the display only one LED will be lit to indicate that
the Channel is panned full left or right.
When using linked channels (stereo inputs), the LEDs light in different patterns, using
a pair of LEDs on either side of the display to indicate the width of the stereo field.
When the stereo image has been collapsed to mono, only the center green LED will be
lit. In this case the stereo input will be heard as mono.
Using Solo Mode
To listen to the Channel you’re editing without hearing the rest of the current mix,
press the
S
OLO
button. Make any necessary changes to the Channel. When finished,
press the
S
OLO
button again or select any other Channel. Both methods will automati-
cally exit Solo Mode and return you to your current mix.
Note: The status of Solo Mode is not saved with a Preset.
Muting a Channel
While creating a mix, any Channel or combination of Channels can be muted. Unlike
the Solo Mode, the changes you make with the
M
UTE
button can be saved as part of a
Preset.