Connecting to a modem, Connecting to a remote pc, Connecting to a remote ascii terminal – Cisco IAD2430 User Manual
Page 68
3-32
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
OL-4234-06
Chapter 3 Installing Cisco IAD2430 Series IADs
Remote Terminal Connections (If Applicable)
Connecting to a Modem
To connect the local modem and the remote modem to live telephone outlets, use standard telephone
cables.
Connecting to a Remote PC
To link a Cisco IAD to a remote PC, follow these steps.
Note
The remote PC must be running terminal emulation software.
Step 1
Connect the remote PC and modem.
Step 2
Set the PC terminal emulation software requirements:
•
9600 baud
•
8 data bits
•
1 stop bit
•
no parity
•
no flow control
Step 3
Key in and dial the telephone number of the Cisco IAD external modem.
Connecting to a Remote ASCII Terminal
To link a Cisco IAD to a remote ASCII terminal, such as a VT100, follow these steps:
Step 1
Connect the remote ASCII terminal and modem.
Step 2
Set the terminal requirements:
•
9600 baud
•
8 data bits
•
1 stop bit
•
no parity
•
no flow control
Step 3
Key in the telephone number of the Cisco IAD external modem, or, if you are using a Hayes-compatible
modem, enter ATDT and the number to be dialed.