360 Systems 1200HD-EX - Manual (Page 53)

Page 52 MAXX-1200 Owner’s Manual
Programming GPI Inputs
The MAXX-1200 has six General Purpose Inputs, referred to as GPI 1 through GPI 6. Each GPI
can be programmed to trigger one of the following events on a channel.
CUE Cue a clip
JUMP Cue selected clip for immediate playback (Playlist Mode only)
NEXT Prepare next clip in a playlist for playback (Playlist Mode only)
PAUSE Pause a clip
PLAY Play a clip
RECORD Start a recording
SELPREV In Playlist Mode – Navigate to clip above currently selected clip
SELNEXT In Playlist Mode – Navigate to clip below currently selected clip
STOP Stop a clip
To program a GPIO Input, select EDIT >CONFIGURE >GPI. The screen of Figure 12 is
displayed. GPI 1 through 6 are the six programmable inputs. The checkboxes to the right of each
selection represent channel 1, 2 and 3. GPI 6 is shown with the trigger option pulldown
expanded.
1. To activate a GPI input, select the event from the pulldown the event menu
2. Mark a checkbox for the channel of interest. The event will be triggered when that GPI goes
active.
3. Click APPLY to activate.
Figure 12 - GPI Configuration Screen