Setting the audio input source, Arming audio tracks, Setting an audio delay time – 360 Systems 1200HD-EX User Manual
Page 40
MAXX-1200 Owner’s Manual
Page 39
Setting the Audio Input Source
Select OPTIONS >CONFIGURE from the Channel 1 Transport Window. The Dialog box in
Figure 5 appears.
• Select an Audio Input by clicking the desired button.
• Click APPLY or OK.
Embedded audio is eight tracks contained in the HD-SDI input video stream.
AES/EBU Digital Audio refers to audio I/O from the optional DXP-2 multi-channel module.
Analog Audio refers to audio I/O from the rear panel XLR-3 connectors.
Arming Audio Tracks
Select OPTIONS >CONFIGURE from the Channel 1 Transport Window.
Refer again to Figure 5 - Channel Configuration Dialog. Under TRACK ARM, check AUDIO to
record audio. All eight tracks are recorded.
Click APPLY or OK
Setting an Audio Delay Time
Audio tracks can be offset from video in 1 millisecond increments up to +/- one second. The setting
is per channel and non-volatile. It applies to playback only, not recording.
You must stop and start the playback to hear the result of a change. This adjustment is made in
Transport mode; once set it also applies to Playlist mode on that channel.
Select OPTIONS >CONFIGURE from the Channel Transport Window. The Dialog box in 10
appears.
Click the OUTPUT tab.
Enter a time offset value in the window.
Click APPLY or OK.