360 Systems 1200HD-EX - Manual (Page 39)

Page 38 MAXX-1200 Owner’s Manual
Making a Recording from the GUI
Video recordings are made using the Transport View of Channel 1. Channel 1 can record or play
clips, but cannot do both at the same time. Channels 2 and 3 are playback only. Use the
following steps to make a recording. Most of the configuration settings can be skipped once a
workflow is established.
Record Configuration Options
If necessary, set Channel 1 to the Transport View. Click FILE >TRANSPORT in the Channel 1
Playlist View to switch to the Transport View.
Setting the Video Bit Rate
Select OPTIONS >CONFIGURE from the Channel 1 Transport Window. The Dialog box in Figure 5
appears.
• In the window, enter the desired Video Bit Rate (in Megabits/sec), not to exceed 125.
Alternatively, use the up/down arrows to set a number.
• Click APPLY or OK.
Figure 5 - Channel Configuration Dialog
The recommended bit rate is 70 to 80 Mb/s, especially for applications requiring file transfer while
all three channels may be in use. Rates over 100 should be used only for applications requiring
reproduction of very high detail material.