O recall, Ì© video level, Language selection – Panasonic PANASYNC TX-D7F21 User Manual
Page 16: Llg osd position, Degauss, S signal
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

<
On-Screen Display>
<
Function and Operation>
O Recall
To return to the initial settings (the settings at the
time of factory shipment).
1) When the lU key (Yes) is pressed, the settings
are recalled and the menu screen returns.
(Recall
=
return to settings at time of factory
shipment.)
2) When the [U key (No) is pressed, the menu
screen returns without the settings being
recalled (the settings return to what they were
immediately before the recall).
*
If no operations are performed for about 30
seconds, the screen goes off without recall.
R e c a l l
O K ?
[H;
Y e s N O :
[D
¡Ì© Video Level
The video input signal level can be matched to
the computer being used. Either 0.7V or 1,0V
can be selected with the [U key.
Note
:
0.7V is typical.
V i d e o L e v e l
0 . 7 V
0.7/1 V ; [5]
(If wrong level is selected image may be too dim
or too bright.)
7ii-
Language selection
The language used by the On-Screen Display
can be selected with the “H” and “B" keys from
among French, English, and Spanish.
FRA
;
French
ENG: English
ESP
:
Spanish
L a n g u a g e
FRA lagra ESP
llg OSD Position
It is possible to adjust the position that the On-
Screen Display is to be shown in.
The On-Screen Display will rotate in a counter
clockwise direction every time the [D key is
pressed.
Degauss
(Demagnetise(See Trouble Shooting Page 17 Third Symptom.))
Degaussing operation can be selected. Use this control if display color is abnormal.
After this is selected, the degaussing action takes place for approximately 6 seconds.
Key operation is not possible while demagnetization is performed.
S Signal
Resolution (1024 x 768) will only appear if the
video signal is a preset or reservation timing
(See page 15).
Signal displays the computer’s approximate
horizontal sync frequency (fH) and vertical
sync frequency (fV).
If the fH or fV are outside the specified range
then the Monitor Self Test function will auto
matically display the Signal Error menu (See
page 9, Monitor Self Test, 2).
1 0 2 4 X 7 6 8
f H 6 0 . 2 k H z
f V 7 4 . 8 H z
- 1 2 -