Panasonic SCCH52 - Manual (Page 19)

Recording from Compact Discs
L_" J ^
• You can use normal and chrome tapes.
• The leader tape must be wound up before-hand. (See page 17)
A EJECT
/■--------'
REVERSE MODE o
^OPE№
CLOSE
Press ^ EJECT on deck 2,
and then insert a tape.
Close the holder.
Press REVERSE MODE to
select the reverse mode.
Z : One side will record, and then
the tape will stop automatically
at the end.
Z> : Both sides will record (forward
side reverse side), then the
tape will stop automatically at
the tape end.
CZ3 : Same as above (When you
press REC PAUSE. “ c Z 3 " will
be automatically switched over
to “ Z5”)-
Press ^ OPEN/CLOSE to load
a CD.
When you record from one disc;
Load a CD on the disc tray 1.
When you record from two or three
disc:
Load a disc from which you want to
record first on the disc tray 1, and in
order 2, 3.
Press ^ OPEN/CLOSE again to close
the tray.
A REC PAUSE
4 C_—.._3
Press REC PAUSE to put the
cassette deck into the record­
ing standby mode.
“[RKTI" will light
5
Press
The recording will automatically start in
the (forward side) direction.
When CD play finishes, the cassette
deck enters the recording standby
condition.
After the compact disc play finishes:
When one disc is loaded:
The cassette deck will create a non-recorded passage of about 4
seconds, and then go into the recording standby state.
When two or three disc are loaded:
When there is a blank portion on the tape, the deck will automatically
start recording from the next compact disc.
To specify the tracks to be recorded:
(Steps 2-7 are from the remote control)
1. Follow steps 1 to 4,
2. Press PROGRAM.
3. Press DISC.
4. Press one of the disc buttons (DISC 1-3) to select the disc.
5. Press \« or to select the track to be edited.
6. Press PROGRAM.
7. Repeat steps 3-6 to program discs and tracks such that the
total playing time is less than the length of the tape (up to 24
tracks),
8. Press ► on the CD changer to start recording.
The recording will automatically start.
19