Panasonic OMNIVISION PV-8402 - Manual (Page 25)

If you are using a cable box and it is connected to your VCR in one of the ways shown in Connection Type A
on page 24, you will need to complete the Cable Box Setup steps below.
2
3
4
5
Cable Box Setup
Complete this page only if Type A
connection method (pg.24) is used.
1
Press ACTION to display
the menu.
Press AW to select “SET UP
CHANNEL," and then press
► to display the “SET UP
CHANNEL" screen.
-.....................MENU----------------------
SET UP VCR
SET CLOCK
SET UP CHANNEL
ID IOMA/ LANQUE:ENGLISH
SELECT:A ▼ KEY
SET :► KEY
END ;ACTION KEY
Press
AT
to select “CABLE/
DSS BOX SET UP,” and
then press ^ to display the
“SELECT HOOKUP” screen.
------- SET UP CHANNEL
ANTENNA ; CABLE
AUTO SET
CAflLE/DSS BOX SET UP
VCR Plus+ CH SET UP
SELECT:A T KEY
SET :► KEY
END :ACTION KEY
Press
AT
to select your hookup,
and then press ^ to set.
• If you selected CABLE/DSS BOX^
VCR^TV, continue with step 5.
If not, press ACTION three times
and turn to page 26.
SELECT HOOKUP
CABLE/DSS BOX^VCR^TV
VCRKIABLE/DSS BOX^TV
VCR^TV
SELECT:A ▼ KEY
SET :► KEY
END ; ACT ION KEY
Press AT to select your cable
box or DSS receiver output
channel number, and then cable / d ;
press ► to enter.
• If necessary, refer to your cable
box manual.
• If you are using AudioA/ideo jack
connections to your cable box, select
and set "VIDEO OUT” as the output channel.
SELECT HOOKUP
CABLE/DSS BO»VCr»TV
X OUTFVT CH
SELECT
SET
END
A V KEY
< ► KEY
ACTION KEY
6
Press ACTION twice to end the setup and
return to the normal screen.
Go directly to “VCR Plus-»- Programming” on page 27.
VCR Ptus-p and PlusCode are trademarks of
Gemstar Development Corporation. The VCR Plus+
system is manufactured under license from Gemstar
Development Corporation.
25