Panasonic OMNIVISION PV-8402 - Manual (Page 18)

Timer Recording
•Important: If the remote control POWER, ACTION, PROG, CHA/T, INDEX, or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
You can set up the VCR to record a one
time, daily, or weekly program while you are
away or otherwise occupied. Up to 6
programs can be stored in memory.
STcheck list before you begin.
I~T All connections are made.
(See pages 6-9.)
n TV and VCR are plugged in and turned on.
□ VCR/TV selector is set to “VCR."
□ Clock is set to correct time.
Q Record tab in place. (See page 5.)
^ Multi Function Display
1
5
6
1
Press PROG* to display the
“SET PROGRAM” screen.
2
Press
AT
to select “TIMER
PROGRAM,” and then press ►
to display the program screen.
• If a program is already in memory, press AT
and ► to select an unused program number.
---------- SET program ------------------
VCR Plus-k PROGRAM
TIMER PROGRAM
SELECT:A ▼ KEY
SET ;► KEY
END :PROG KEY
START STOP CH
SELECT START DATE
SELECT :A T KEY
SET :► KEY
E№ :PHOG KEY
3
Press
AT
and
►
to select and
set one of the following:
• 1-31 =One time recording
• DAILY =Same time MON-FRI
• WEEKLY (SUN-SAT) =Same time once a week
Example ^8-9............... 3 1 — 1 — 2 ..........6 -
Today’s Date — 7 SELECTA /T Selection Order DAILY
L*,WEEKLY........... WEEKLY WEEKLY _J
(SAT) (MON) (SUN)
Press
AT
and
to select and set each
of the remaining
items at right.
Remaining items to be set:
• START time
• STOP time
• CH(annel) number, or LINE for
outside source recording
• Speed (SP, LP, SLP)
To Make Corrections
Repeatedly press ► to move the cursor to the right, or to
move to the left to the incorrect entry and make the correction.
5
Press PROG to end the program.
• This screen appears for confirmation.
To Enter More Programs
Press AT and ► to select and set a blank
program number, and then repeat steps 3 and 4.
Press PROG to exit this mode.
Press POWER off to set the timer.
• When recording programs via a cable box,
make sure the cable box is left ON and
tuned to the desired channel.
P DT START STOP CH SPD
CANCEL
SELECT
ENTER
END
AOO/D
1'8:A
► KEY
PROG
-T KEY
T KEY
CEY
Multi Function Display
Important notes when using a DSS receiver
• When recording programs via a DSS receiver, the DSS receiver must be left on.
• When recording programs via an antenna or cable, the DSS receiver must be turned off.
• A cassette with no record tab is ejected and TIMER” flashes when the power is turned off to set the timer.
• If the start times of two programs overlap, the lower numbered program will have priority.
• If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 17),
the timer recording will not be performed.
• If there is a power interruption of more than one minute, the recording will not be performed or continue.
18