Panasonic PV-M2768 - Manual (Page 26)

VCR Plus+ Programming
Eosy Taping.
‘Important;
If the remote control POWER, CH , MENU, PROG, ON-TIMER, R-TUNE,
FM/TV and ADD/DLT button does not work when pressed, press the MAIN
button on the remote control and try the button again. |\j^Before you begin, make sure.
D The clock is set.
Q VCR Plus+ Setup is complete
(See pages 24, 25).
PROGRAM TIMER Indicator
1
Press PROG* to display the SET
PROGRAM screen.
2
Press AV to select “VCR
Plus-i- PROGRAM” and then
press ► to display the Plus
Code screen.
............SET PROGRAM.....................
TIMER PROGRAM
ENTER PLUSCODE NUMBER
USING 0-9 KEYS
«5 Press NUMBERED keys to enter
the PlusCode number from your
local TV listings.
To Make Corrections
Press M repeatedly to delete the PlusCode
number. Then, enter the correct number.
ENTER PLUSCODE NUMBER
123456
USING 0-9 KEYS
BACKSPACE:4 KEY
ENTER ;PFIOG KEY
4
Press PROG to lock in your program.
5
Press the 1,2, or 3 key to select
the program type.
i once
2 DAILY(MON-FRI)
3 WEEKLY
TO SELECT PUSH 1. 2 OR 3
To Change the Recording Speed
Press SPEED for SP. LP, SLP.
To Chancel Program Contents
Press ADD/DLT.
• If you use connection type "A" on page 24, the
channel shown in this on-screen display will
always be the cable box output channel number.
DATE START STOP CH
8SAT10:00P12:0OP125
TO CHANGE RECORD SPEED
PUSH SPEED KEY
CANCEL:ADD/OLT KEY
ACCEPT; PROG KEY
B Press PROG to end the program.
• This screen appears for confirmation.
P OT START STOP CH SPD
1 day 9;00a 12:00a 08 SP
3------------ :----------- __
CANCEL:ADD/DLT KEY
SELECT 1
-e:A ▼
KEY
ENTER :► KEY
END :PROG KEY
Use normal Timer Recording
steps if:
• the PlusCode for a program is
not listed.
• you anticipate the program, such
as a sporting event, to run over
the scheduled stop time.
See page 19 to:
• cancel a timer recording in
progress.
• replace program contents.
• review or clear program contents
once set. 26
7
Press PROG twice to exit this
mode and return to the normal
screen.
• The PROGRAM TIMER indicator lights on
the front panel.
• If you're using a cable box, make sure that
it is tuned to the desired channel and the
power is left on for timer recording.
LEAVE CABLE BOX POWER ON
FOR TIMER RECORDING
This display appears if
you use a cable box.
• You can obtain unlisted PlusCode numbers by calling
1-900-454-7587. Call costs approximately $.95 per minute.
• Avoid overlapping program times.
• An on-screen display will indicate if an invalid PlusCode
number has been entered or when all timer programs
are full.