Panasonic PV-M2768 - Manual (Page 24)

VCR Plus+ Setup
Eosy Toping.
*lmportant:
If the remote control POWER, CH at , MENU, PROG, ON-TIMER, R-TUNE, FM/TV and ADD/DLT button does not work
when pressed, press the MAIN button on the remote control and try the button again.
VCR Plus-i- programming allows you to set most items of a timer recording by simply entering a special code (PlusCode)
found in TV GUIDE magazine as well as the TV listings in selected newspapers. In order for your Combination VCR to do a
VCR Ptus+ recording, or a timer recording of cable stations, some setup is required.
At first, choose your Connection
туре.
(Then, follow the instructions under the diagram.)
Connection Type A
Back of
Combination VCR
Cabie Box
^*BfO @*ioo__
RF Coaxial Cabla
(not aupplied)
Cable/
Antenna
Front of
Combination VCR
VIDEO IN L-AUDIOIN-R
If your system looks like this, do the
following.
1. Complete the “Cable Box Setup”
section at right.
2. Skip page 25 and go directly to page
26 for VCR Plus+ Programming.
Connection Type В
Back of
Combination VCR
From Antenna
or Cable
Cable/
Antenna
RF Coaxial Cable
(not supplied)
If your system looks like this, do the
following.
1. Skip the “Cable Box Setup”
section at right and turn to page 25.
2. Complete the “VCR PI us - f Channel
Setup” section on page 25.
3. Turn to page 26 for VCR Plus+
Programming.
VCR Plus+ and PlusCode are
trademarks of Gemsfar Development
Corporation,
The VCR Plus+ system is manufactured
under license from Gemstar Development
Corporation. 24
Cable Box Setup
For Connection Type A (see left) only
1
Press MENU* to display the
MAIN MENU.
2
Press to select
“CH,” and then press MENU
to display the SET UP
CHANNEL screen. SELECT rA T ► KEY
SET :MENU KEY
3
Press
AT
to select “CABLE
BOX SET UP,” and then
► to set.
[ --- SET UP CHANNEL ---
1
ANTENNA SYSTEM :
1 AUTO SET
CATV
■CABLE BOX SET UP
VCR PÌUS+ CH SET UP
SELECT ; a
¥
KEY
SET :► KEY
END :MENU KEY
^ Press
AT
and to select
“YES” or “NO," and then
press ► to set.
Select YES if all channels are
received via the cable box
(connection “A” at left). Then, go
to step 5.
Select NO if your cable connection resembles “B” at
left. Press MENU to exit and turn to page 25.
ARE YOU USING
A CABLE BOX?
YES
SELECT ; a ¥ KEY
SET :► KEY
END :MENU KEY
Press
AT
to select Cable
box output channel number,
and then press ► to enter.
• If necessary, refer to your cable
box manual.
• If you are using AudioA/ideo jack
connection for your cable box,
select and sot “VIDEO OUT' as
the output channel.
ENTER CABLE BOX OUTPUT
CHANNEL
ЕШ
SELECT : a ¥ KEY
YOUR TV IS RECEIVING
THE OUTPUT OF CABLE BOX
CH 01
This display appears for
5 seconds. (Channel
shown is example only)
S
Press MENU twice to end the setup and return to
the normal screen.
Go directly to VCR Plus+ Programming on page 26.