Panasonic PV-M2768 - Manual (Page 10)

On-Screen Displays (OSD)
*lmportant:
If the remote control POWER, CH at , MENU, PROG,
ON-TIMER, R-TUNE, FM/TV and ADD/DLT button does
not work when pressed, press the MAIN button on the
remote control and try the button again.
Channel & Function Display
Whenever the channel is
changed, the channel
number will appear for a
few seconds on-screen.
(Some station names may
also appear.)
When a function button is
08
WNET
Combination VCR mode wiil be
displayed.
• When a recording is started, both REC and
the channel number will appear together.
Menu Screen
1
Press MENU* to
display the MAIN
MENU.
2
Press and
MENU to make your
selection (see page 8).
• To get the most from each feature, please read
the Operation Manual before attempting any
operation.
VCR Status & Clock Display
Press DISPLAY to display and remove the
overlay shown below.
LffBbAGE
EXIT
SELECT ;
A
¥ -< ► KEY
SET ;MO*J KEY
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
If no active channels are
found for CHANNEL
MEMORY...
(see page 5.)
If you attempt to set or
review a Timer Recording or
set the On-Timer and the
Clock is not set...
(see pages 8, 9.)
If you press REC on the
remote control or the
Combination VCR, and a
cassette is inserted with no
record tab...
(see page 17.)
If you press STOP
during a Timer
Recording...
(see page 19.)
If you press PLAY, FF,
REW, or REC on the
remote control or the
Combination VCR without
a cassette inserted...
(see pages 16, 17.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
PLEASE SET CLOCK
BEFORE PROGRAMMING
CHECK CASSETTE
RECORD TAB
TO CANCEL TIMER REC
HOLD DOWN STOP KEY
FOR APPROK 3 SEC
NO CASSETTE
PLEASE INSERT A CASSETTE
Function
Status
Current
Time
Rec Time
Remaining
(OTR mode
only see
page 17.)
X__L
REC 12:00AM WNET
0;25 0:00:00
OSTEREO <- 1 SLP
»SAP
MONO
Channel &
Cali Letter
^Tape Speed
Receivable
Broadcast Types
(See page 22.)
Tape Counter
If the Combination VCR is
not in Stop mode or a
cassette with record tab is
not inserted two minutes
before a Timer Recording
is about to begin...
(see pages 18,19.)
If head cleaning becomes
necessary while playing
back a tape...
(see page 28.)
PLEASE PREPARE
FOR TIMER REC
VIDEO HEADS MAY
NEED cleaning
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END 1 PLAY KEY
Blank Tape/ No Video Signal Indication
When a blank section of tape comes up in Play
mode, or the selected channel has no
broadcast signal, the TV screen will turn a solid
blue.
10
If you press a function
button other than
STOP/EJECTor POWER
while the Combination VCR
is in VCR Lock mode...
(See page 20.)
VCR LOCK ACTIVATED