Information for your safety, Warning – Panasonic PV-PD2000 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Information for Your Safety
WARNING
TO REDUCE THE RISK OF FIRE OR
SHOCK HAZARD AND ANNOYING
INTERFERENCE. USE ONLY THE
RECOMMENDED ACCESSORIES AND DO
NOT EXPOSE THIS EQUIPMENT TO RAIN
OR MOISTURE.
DO NOT REMOVE THE COVER (OR
BACK);THERE ARE NOT USER
SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
•As this equipment gets hot during use,
operate it in well ventilated place; do not
install this equipment in a confined space
such as a book case or similar unit.
(U.S. only)
This device complies with Part 15 of the FCC
Rules. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS :
(1 )THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE. AND
(2)THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED.
INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
(Canada Only)
COMPLIES WITH CLASS B LIMITS OF
ICES-003 OF INDUSTRY CANADA.
CONFORME AUX LIMITES PRESCRITES
POUR APPAREILS DE CLASSE B DE LA
NORME NMB-003 D’INDUSTRIE CANADA.
FCC NOTE:
(u
.S. only)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
•Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced
radioATV technician for help.
FCC Caution : To assure continued
compliance, follow the attached installation
instructions and use only shielded cables
when connecting to computer or other
devices. Also, any changes or modifications
not expressly approved by the party
respossible for compliance could void the
user’s authority to operate this equipment.