Panasonic PV-PD2000 - Manual (Page 21)

Printing for 16 Mini-frame Pictures
16 mini-frame pictures are printed separated by white lines.
(These lines are also displayed on the television screen.)
Use the ▼ Button to select
“ALBUM”.
FORMAT
STD
MULTI
___ STROBE
16ZU
l< ^ ►] SELECT [ENTER] END
Check that the PRINT Lamp
is lit up.
• If the entire ALBUM Screen is
not stored in memory, press
the MONITOR Button to light
up the PRINT Lamp.
FORMAT
STD
[^'ALBUMI
MULTI
----- STROBE-
RÌ 9 16 I
[< ^ ►JSELECT [ENTERIEND
8
PRINT
Then press the PRINT
Button.
• Printing starts.
Remarks, etc.
J
or
Use the < and ^ Buttons to
select the desired number of
mini-frames.
■To Erase Stored Pictures
Press the CLEAR Button when the PRINT
Lamp is lit. One frame is erased each time the
CLEAR Button is pressed.
(To store new pictures to replace the erased
pictures, press the MONITOR Button so that
the PRINT Lamp turns off, and then press the
MEMORY Button.)
■Storing Pictures Again after All the
Pictures Are Stored
Press the MONITOR Button so that the PRINT
Lamp turns off, and then press the MEMORY
Button. (See Step 6 on the previous page.)
■To Abort the Setting Process
Press the CLEAR Button twice when the
PRINT Lamp is turned off.
Hints for Use
•The PRINT Lamp lights up and turns off each
time the MONITOR Button is pressed.
• If you press the MONITOR Button again after
printing is complete, the display returns to the
MEMORY Screen, allowing you to print the
same pictures again.
•To allow printing without the entire ALBUM
Screen stored in memory, press the
MONITOR Button to light up the PRINT
Lamp. The ALBUM Screen will be printed
with white spaces where no image was
saved. (In this case, the pictures are still
stored in memory starting from the upper left
corner. There is no editing operation that
makes it possible to print images
interspersed with blank (white) images.)
a
c
o
o
■a
21