Panasonic CT-30WX50 - Manual (Page 23)

ASPECT Controls
Mode Picture Explanation
Panasonic
AUTO
Image is expanded
Changes in accordance
with the Panasonic
^ AUTO mode setting
(Refer to page 22)
The display wilt automatically become enlarged
(depending on the picture source), allowing you to view
the picture at its maximum size.
Note:
(1) If Panasonic Auto mode is selected, the image may
change size suddenly, according to program
material.
(2) There may be a slight delay for the screen size to
adjust. If a 480p or 1080i signal is input during
component input signal mode, the controls will not
operate.
NORMAL
NORMAL will display a 4:3 picture at its standard 4:3
size.
ZOOM
ZOOM mode magnifies the central section of the picture.
FULL
-16-
3 «f T
oV_ Jo
FULL will display the picture at its maximum size but
with sight elongation.
JUST
3 ^
JUST mode will display a 4:3 picture at maximum size
but with aspect correction applied to the center of the
screen so that elongation is only apparent at the left
and right edges of the screen. The size of the picture
will depend on the original signal.
Notes:
(1) The S-VIDEO terminal on this set can detect specially encoded signals that are compatible with a wide screen monitor.
When a full image from the S-VIDEO terminal of specially encoded video is detected by the set, the screen size is
automatically set to FULL mode.
(2) The screen size also changes if ID-1 is detected.
(3) The screen size will also change if Si detection has been set.
23