Panasonic NN46110-600 - Manual (Page 62)

52 Chapter 2 Configuring servers
• Attribute—1 (AV Pair)
The supported syntax is:
[Prefix] [Action] [Protocol] [Source] [Source Wildcard Mask] [Destination]
[Destination Wildcard Mask] [Operator] [Port]
The following table describes the syntax of the attributes.
Table 3 Syntax of attributes
Section Description
Prefix ip:inacl#Num=
ip:outacl#Num=
Where "Num" is replaced with a number specifying the
order in the list. Inacl and outacl are the only two AV pair
types supported.
Action Deny or permit
Protocol IP TCP UDP, or ICMP
Source An IP Address, "any", or "host
Source wildcard mask This is not used if the source is "any" or "host". Note the
mask is NOT specified as a subnet mask. "0" indicates
exact match for an octet. "255" indicates a "don't care" for
all of the bits in the octet.
Destination An IP address, "any", or "host "
Destination wildcard mask This is not used if the source is "any" or "host". Note the
mask is NOT specified as a subnet mask. "0" indicates
exact match for an octet. "255" indicates a "don't care" for
all of the bits in the octet.
Operator LT - Less than, GT- Greater than, EQ - Equal, NEQ - Not
equal
Operator is not used unless the protocol is TCP or UDP.
Port Port number. Must be provided if an operator is specified.
Do not specify an outacl that denies all traffic, such as ip:outacl#1=deny ip any
any, because this prevents the IPsec client from connecting to the banner server.
You must have at least one outacl entry specified. You can specify a "deny all”
filter in the group.
NN46110-600