Panasonic NN46110-600 - Manual (Page 60)

50 Chapter 2 Configuring servers
5 In the Maximum Transmit Attempts , enter the number of times that you
want the VPN Router to try to connect to the RADIUS servers before failing.
By default, the VPN Router tries three times.
6 Click the RADIUS Diagnostic Report link to check that your RADIUS
Authentication configuration is correct. This report compares the settings on
the RADIUS Authentication window to the corresponding settings on other
VPN Router configuration windows. The title of each section of the
diagnostic report lists the name of the related window. For example, the IPsec
RADIUS Configuration section of the report contains information related to
the Services > IPsec window.
7 Enable a server and enter the server’s host name or IP address, the interface
type, port number (1645), and secret. Click OK .
8 Select Services > IPsec and click Add RADIUS to add a RADIUS server to
the Authentication Order table.
9 Select Profiles > Groups to add or select the default group for RADIUS users
(this is the group a user is assigned to if the RADIUS server does not send
back a class attribute).
10 Select Profiles > Groups > Edit > IPsec Configure .
11 The Authentication section shows the Authentication method for the group
selected. Enter the group ID and group password. Consider using the LDAP
group name as the default group, because you must remember a default name
once you enter it. If your RADIUS server returns a class attribute, ensure that
the authentication method is enabled for that group. However, you do not need
a group ID and group password for the group that is being returned as a class
attribute.
Note: You must set the group ID and password in the Nortel VPN client
as well as in the group profile to use RADIUS authentication.
To configure IPsec and RADIUS on the client:
1 In the VPN Client GUI, select Options > Authentication Options and click
Group Security Authentication
2 Enter the group ID and group password.
NN46110-600