L2tp/ipsec authentication – Panasonic NN46110-600 User Manual
Page 106
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
96 Chapter 3 Using certificates
L2TP/IPsec authentication
In the Authentication section, complete the following information:
1
Under
Local UID
, enter the
user ID
of the local VPN Router that you are
configuring.
2
Under
Peer UID
, enter the
user ID
of the remote VPN Router that you are
configuring.
3
Enter the
password
for the local UID, then
confirm the password
to verify
that you entered it correctly. If you selected a variation of MS-CHAP V2
authentication, no password is required for the Local UID.
4
Click
Enable
or
Disable
to enable or disable compression.
5
Click to enable or disable the
Compression/Encryption Stateless Mode
option. This option is not used if encryption and compression are both
disabled.
6
The
L2TP Access Concentrator
(for L2TP authentication only) field appears
if you selected L2TP as the preferred tunnel type for the branch office
connection. Use this entry to specify the L2TP access concentrator that you
want to perform authentication between the VPN Router and the NAS.
7
Select an
IPsec data protection minimum level
(Triple DES, 56-bit DES, or
Authentication Only).
8
Select a
valid issuer CA
from the list.
9
Enter the
DN
to identify the remote branch office site.
10
Select the
server certificate
issued by the same CA as the remote branch
certificate from Local Identity list.
11
Click
OK
.
NN46110-600