Panasonic KX-RC105 - Manual (Page 111)

Troubleshooting Guide
Trouble Cause Procedure
The display shows
“CHANGE LITHIUM
BATTERY"and CPA
will not accept any key
function.
The life of the lithium
battery is terminated.
Go to a service center
to have the battery
pack exchanged. (See
the included list of
authorized service
centers.)
CPA does not print
correctly or printing is
blurred.
The ribbon cassette is
not installed or is
installed incorrectly.
install the ribbon
cassette correctly.
(See p. 113)
The ribbon cassette is
run out.
Replace with new
ribbon cassette.
(See P. 113)
The printing positions
are not correct.
Setting the printing
positions is wrong. Set the printing
positions correctly.
(See p. 26)
A check is not fed. A check is not set on
the printer correctly. Set a check on the
printer correctly.
(See p. 35)
The display shows
“MEMORY ERROR”.
CPA does not operate
properly, or memory
may contain garbled
characters.
Noise on the AC line
or static electricity may
prevent CPA from
operating properly. Turn the power switch
off for a few seconds
then turn the power
switch on again. If the
CPA does not function
properly, reset the
CPA (p. 112), and then
print the records on the
paper roll. If the CPA
still does not function
properly, perform a total
reset following the
procedure on p. 17.
O
(D
3
o
u
3
o
3
Q>
Troubleshooting
111