Panasonic KX-RC105 - Manual (Page 110)

Troubleshooting Guide
When trouble occurs, check the following points before returning CPA for
service.
Trouble Cause Procedure
Press a key but
nothing appears on the
display.
CPA is not turned on. Turn the power switch
on.
(p. 16)
Turn on the power
switch, but nothing
appears on the display. The battery is not
charged. Charge the battery for
about three (3) hours.
(p. 12)
The battery pack is
not installed. Install the battery
pack. (p. 115)
The protective sheet
has not been removed
from the battery
terminal.
Remove the protective
sheet, (p. 6)
The power switch is
not operated correctly.
Try turning on again
following procedure on
p.16. If nothing
appears on the display,
press the reset switch
with a pointed object
like the tip of a pen
(p. 112) then slide the
power switch again.
The remaining battery
amount is incorrectly
displayed. The battery has
become inactive.
Keep operating CPA
until “WEAK
BATTERY” is
displayed then
recharge the battery.
(P- 12)
The display shows
“INSERT AC
ADAPTOR” and CPA
will not accept any key
function.
The battery is empty. Plug in the AC adaptor
and charge the battery
for about three (3)
hours, (p. 12)
Troubleshooting (continued)
110